71
Exit the function
or data change
Confirm access
or data change
Scroll
(LEFT /
RIGHT)
Delete
selected
character
Data
decrease
of data
Scroll
(UP /
DOWN)
Enter
selected
character
Par.
"JOB MENU" - MENU
15.7
Menu
Job settings menu
1
Press
Menu
.
2
Press the key at the side of menu
Menu
.
Fig. 186
In this screen it is possible to access several different menus, which can be useful during spraying:
•
Valves
(par. 11.4.5).
•
Alarms
(par. 11.4.10).
•
Working parameters
(par. 11.4.11).
•
Speed source
(par. 15.7.1).
•
User
(par. 11.8).
15.7.1 Speed source
Fig. 187
Allows to select the source for speed calculation. Available options:
• GPS
Information concerning speed is received by the GPS, which is connected directly to the monitor.
• Wheel sensor
When this option is enabled, the speed is calculated on the basis of the pulses received by the
speed sensor installed on the wheel.
WARNING: guidance information and all accessory functions
(surface calculation, alignment, etc.) are disabled.
The wheel constant must be entered during the setup procedure (par. 11.4.7).
• GPS and Wheel sensor
When this option is enabled, the monitor uses both sources:
- the guidance information and the accessory functions are active thanks to the data sent by the
GPS receiver;
- the output is adjusted (par. 13.2) according to the speed read by the wheel sensor.
• Simulation
Allows to enable speed simulation in order to carry out adjustment tests even when the machine is stationary.
SIMULATION
SPEED
Fig. 188
Edit simulation speed
(DEF 6.0 km/h - 3.7 MPH)
:
F3
(
+
) increases,
F5
(
-
) decreases
WARNING: guidance information and all accessory functions
(surface calculation, alignment, etc.) are disabled.
