Arachnid CMX5000, Инструкция по эксплуатации

Страница: 3 / 29

Setup / Mounting Instructions
Choose a location to hang the dartboard where there is about 10 feet of open space in front
of the board. The “toe-line” should be 7’ 9 1/4” from the face of the dartboard. (8 feet away to
observe soft tip rules) Since this dartboard is powered with an AC adapter, you may want to
mount it close to an electric outlet for convenience.
The mounting holes on this dartboard set are 16” apart so it can be mounted securely on wall
studs in your home. Locate a wall stud and place a mark 82 ¼ ” from the floor. Measure 16”
from your first mark (staying level with the first mark) and place the second mark on the wall,
which should be over another wall stud (refer to diagram on next page).
Screw 2 mounting screws in the center of the studs using the marks you made as guides. Be
sure the screws are level to ensure an accurate playing surface. If not mounting into studs,
be sure to use drywall anchors or other securing hardware appropriate to the wall you are
using.
Mount the dartboard on the wall by lining up the hang holes on the back with the screws (see
diagram below). It may be necessary to adjust the screws until the board fits snugly against
the wall. If you want to mount the dartboard even more securely to the wall, you can fasten
four screws through the holes located in the catch ring area (the area outside the scoring
segments).
Center of bullseye should be 5’ 8” from the ground.
Plug the A/C adapter into the wall outlet and into the jack at the bottom right of the dartboard
and you’re ready to play.

16”

Hang Brackets