Version: 20220329
8
8
Spring loaded thumb screw (4x)
Can be loosened to position the optic body. The optic body and
lens of the FireCatcher Camera are pre-aligned at factory so no
need to use.
9
Optic unit
Contains the CMOS sensor component.
10
(not present on FireCatcher Camera)
11
(not present on FireCatcher Camera)
12
(not present on FireCatcher Camera)
13
(not present on FireCatcher Camera)
14
(not present on FireCatcher Camera)
#
Name
Function
15
Camera I/O connector
I/O of the camera electronics. This connector is linked to the
interface board. Do not use or modify this connection.
16
RS485 connector
Communications interface of the camera electronics. This
connector is linked to the interface board. Do not use or modify
this connection.
17
Power connector
Connect external power wires from the power/alarm cable to
this connector. Polarity is indicated on the connector.
18
Network connector
Connect external network cable to this connector.
19
microSD card slot
Do not use this storage interface. It can interfere with the fire
detection functionality when in use.
20
Audio in
Not used.
21
Audio out
Not used.
22
Status LED
See table below.
23
Control button
Can be used for resetting the camera to factory default settings.
Warning: Image settings have been optimized for fire
detection. Executing a factory reset will destroy this optimal
setting and may result in fire detection failures. Refer to the user
manual to configure these settings.
24
Cable Gasket M20 (x2)
IP 67 entry for the power/alarm cable and Ethernet cable
25
Iris connector
Connected to the lens for remote zoom and focus control.
Status LED behavior
