AR 10036390, Руководство по эксплуатации и обслуживанию

Страница: 25 / 56

Model 800A3B
Rev D 9
2.2.3 Main Power Circuit Breaker
The Main Power circuit breaker, CB1, is located on the rear panel of the cabinet.
REMOTE INTERFACE
CONNECTORS
CB1 AC LINE
ENTRY
Figure 2-2. Rear Panel Features
2.2.4 RF ON/OFF
The RF ON/OFF touch screen menu selection toggles the amplifier from a Standby to an Operate mode. The
status of the function is indicated on the display as RF ON or RF OFF. In the RF ON state, RF output is
enabled according to control settings and amplifier RF input. In the RF OFF state, there will be no RF output.
2.2.5 RESET Function
The RESET function is a touch screen menu selection that will cause the amplifier to attempt to reset.
Selecting Reset may clear the fault, depending upon the type of fault that has occurred. If the amplifier is in
an over-driven condition, lowering the amplifier’s gain or RF input level should enable the function to reset
the amplifier. If using the Reset function does not clear the Reset indication, refer to section 3.5, Fault
Detection Circuits and section 4.2, Fault Signal Interpretation and Diagnosis in this manual.