WWW.AQUAVISION.CO.UK
Tel: +44 (0)1992 708333
LCD TV INSTALLATION INSTRUCTIONS
LCD TV INSTALLATION INSTRUCTIONS
LCD TV INSTALLATION INSTRUCTIONS
LCD TV INSTALLATION INSTRUCTIONS
Applies to models AVF17W
Applies to models AVF17W
Applies to models AVF17W
Applies to models AVF17W----4FK & AVF
4FK & AVF
4FK & AVF
4FK & AVF24
24
24
24W
W
W
W----4FK
4FK
4FK
4FK
Once the main back bezel of your AQUAVISION
®
has been installed, the LCD TV needs to be fitted. The first and
most important job is to remove the clear protective film from the front of the screen.
If necessary clean the front of the screen thoroughly. When cleaning the AQUAVISION
®
LCD, never use an
abrasive cleaner. The front of the screen has a soft plastic finish and therefore should be cleaned with a soft damp
cloth and a mild, non-abrasive glass cleaning agent.
Once you are satisfied that the screen is clean, remove the plastic nuts from the support brackets.
Connect all relevant cables into the back of the LCD screen, making sure they are pushed fully home. Don’t forget
the speaker wires!
Place the LCD screen onto the support brackets as shown and replace the plastic mounting nuts.
You are now ready to install the glass cover. Please refer to the instructions supplied with the glass showing how
this should be carried out.
It is the installer’s responsibility to ensure that the AQUAVISION
®
unit is installed and sealed correctly as stated in
these instructions. Your guarantee will be void if any problems are caused through installation faults or poor sealing.
After any maintenance, you will need to completely clean the old silicon off and re-seal as stated in the glass fitting
instructions.
The specifications shown were accurate at time of going to press. AQUAVISION
AQUAVISION
AQUAVISION
AQUAVISION’S
SS
S
®
policy of continuous development means some changes may take place. Please check with the office for
confirmation. All screen pictures simulated. All names and trademarks acknowledged. E. & O.E.
REV 4.0.2
