WWW.AQUAVISION.CO.UK
Tel: +44 (0)1992 708333
GLASS INSTALLATION INSTRUCTIONS
GLASS INSTALLATION INSTRUCTIONS
GLASS INSTALLATION INSTRUCTIONS
GLASS INSTALLATION INSTRUCTIONS
Applies to models AVF17W
Applies to models AVF17W
Applies to models AVF17W
Applies to models AVF17W----4FK & AVF
4FK & AVF
4FK & AVF
4FK & AVF24
24
24
24W
W
W
W----4FK
4FK
4FK
4FK
Once the main body of your AQUAVISION
®
has been installed, the glass cover needs to be fitted. The first and most important job is to
clean the front of the screen and the back of the glass thoroughly. You will also need to ensure that the metal surround is clean and free from
any plaster, grout, building residue, etc. as this will affect the AQUAVISION
®
’s waterproofing properties.
When cleaning the AQUAVISION
®
, never use an abrasive cleaner. The front of the screen has a plastic finish and therefore should be
cleaned with a soft damp cloth and a mild, non abrasive glass cleaning agent.
Once you are sure that all areas are totally clean, gently place the glass cover in front of the LCD screen, and slide down about 5mm.
Check for any dirty marks, etc. and, if necessary, remove the front and re-clean.
Once you are happy with the cleanliness of the screen, and the glass is positioned correctly, power the television up to make sure that no
cables have been dislodged during the cleaning or installation process. If they have, remove the glass any mistake.
Aquavision Glass
Wall
Aquavision
Mounting Bracket
Silicone
Waterproof Sealant Strip
Once you are satisfied that all connections are good, turn the unit off. You will now need to apply a clear line of silicone sealant to the joint
between the sides of the front glass plate and the tiles/wall. This will inhibit any potential build up of soap/shampoo residue and mildew, etc.
that may build up in this area. (The better this siliconing is, the less cleaning you will have to do later!) Make sure that the silicone is worked
well into the joint evenly and that there are no gaps or bubbles, etc. Wipe away any excess silicone using a cloth with white spirit on it and
visually check for any bubbles or gaps. Rectify as necessary and re-check. When you are completely happy you have a waterproof seal, leave
48 hours for the silicon to dry before use. You should regularly check the soundness of this joint and rectify as necessary. It is the
responsibility of the installer/customer to make sure that the AQUAVISION® unit is installed and sealed correctly; your guarantee will be
void if any problems are caused through installation faults or poor sealing. After any maintenance, you will need to completely clean the old
silicone off and re-seal as stated above.
Should you need to remove this panel at any time, you should run a sharp knife down the line of silicone around the glass. You will need to
completely remove all old silicone before replacing the glass and then re-apply the silicone as stated above.
The specifications shown were accurate at time of going to press. AQUAVISION
AQUAVISION
AQUAVISION
AQUAVISION’S
SS
S
®
policy of continuous development means some changes may take place. Please check with the office for
confirmation. All screen pictures simulated. All names and trademarks acknowledged. E. & O.E.
REV 4.0.1
