Dear AquaVac Owner:
Thank you for choosing AquaVac. In order to achieve optimal performance, please read
and follow these steps:
1. Allow the cleaner the first 10 minutes of each use to calculate pool size and configuration.
The normal programmed cycle is not designed to begin until after this period.
2. Cleaner filter cartridges should be thoroughly cleaned after each use or as often as
needed to ensure cleaner's optimal performance.
3. Before using your cleaner and especially when opening the pool for the first time
remove larger items from the pool that may diminish the cleaner's performance. Clean
filter frequently when pool is excessively dirty.
4. For the first use, run cleaner for the full cycle (2 hours) to ensure a clean pool and give
yourself a full understanding of the cleaner's capabilities. Subsequent cleanings may
take less than a full cycle.
5. Cleaner may periodically go to the wall but not necessarily climb to the vertical position.
This is a normal part of the programmed cycle.
6. Cleaner may stop in the middle of the pool and reverse during cleaning cycle. This is
a normal part of the programmed cycle.
7.
DO NOT
start cleaner out of the water. Power button should only be switched to
"On"
position when unit is submerged. The unit will automatically shut off, but it is best to
put power switch in
"OFF"
position when unit completes cleaning.
8. Plug in only to a protected 220-240 volt AC outlet that is close and protected from
short-circuits. Fit a 30 mA differential protection device to protect people from electric
shock caused by a possible break in the electrical insulation.
9. Place the cleaner power supply so that it is at a minimum distance of 3.5 meters from
the pool edge. The length of the standard cleaner cable is 15.24 meters.
QUESTIONS?
CALL 0 825 000 549
(0.15
€
/min)
for Additional Technical Assistance
STOP
READ THESE IMPORTANT OPERATING
TIPS BEFORE USING YOUR UNIT!
