12 cm
(4.7 inch)
3.6m/11.8ft
1
1a
1.
Place the power supply (transformer) at least 3.6 meters / 11.8 feet from the pool and at
least 12 cm / 4 Inch above the surface (fig.1). The transformer will supply low voltage to
the cleaner.
2.
Uncoil the cable.(fig.1a)
unit
Operating the pool cleaner - Quick start guide
4.
Plug the cable into the power supply. Depending on your model (
Type I
or
Type II
),
make sure the key on the plug corresponds exactly with the key slot on the socket of
the power supply (fig.3a).
(See details on the next page)
5.
Plug the power supply into a grounded outlet. Ensure that the electric outlet has been
properly grounded (fig.3b).
6.
Press the “ON” button on the power supply (fig 4). The light will glow indicating that the
system is “ ON “ and the pool cleaner will start the cleaning cycle. The unit keeps
record of the number of cleaning cycles. Only an authorized service center can
display the accumulated cleaning cycles.
3.
Place the unit in the water.
Turn the unit side to side
in the water to allow air to
escape from the body
and then let the cleaner
sink to the bottom of the
pool (fig.3). Then, spread
the cable over the
surface of the pool as
evenly as possible (fig.1).
3
3a
3
3b
Type I
Type II
4
IMPORTANT:
Please be sure to always keep your pool cleaner properly stored anywhere
between 10 to 40 degrees Celsius (50 to 104 degrees Fahrenheit). This will
keep the motors, plastics and seals protected. Failure to comply will result in
loss of warranty.
Robot can be used in water with temperatures ranging from 13°C to 35°C (55°F
to 95°F). However, the recommended optimal temperature is between 22°C
and 32°C (72°F and 90°F)
Содержание Max 3
Страница 1: ...BK 0012600 2 37 30 23 16 9 ...
