AquaTechnix AQUA 4 Fun 100, Оригинальное руководство по установке и эксплуатации

Страница: 34 / 52

| 34
Malfunctions / Trouble shooting
Display Component Possible fault Solution/Reason
P01 Water inlet temperature
sensor Sensor faulty or cable
connection loose Check sensor and cable connection
P02 Water output temperature
sensor Sensor faulty or cable
connection loose Check sensor and cable connection
P04 Outdoor temperature
sensor Sensor faulty or cable
connection loose Check sensor and cable connection
P05 Temperature decrease
sensor No use
P07 Evaporimeter Sensor faulty or cable
connection loose Check sensor and cable connection
P08 Hot gas temperature
sensor No use
E01 High pressure sensor Flow switch defective,
low coolant level, sensor
defective Check fl ow Switch, compressor,
measure outdoor temperature.
change sensor.
E02 Low pressure sensor Low pressure fault in the
cooling circuit System iced, coolant leaked.
Outdoor temperature too cold.
nFL Flow sensor No water fl ow, fi lter pump
off, air in the system,
bypass open too wide
Filter pump off, air in the system.
Bypass open too wide. Shut-off
device closed.
E06 Temperature differencs
ON/OFF too high Insuf fi cient water fl ow Check fl ow, check fi lter pump
E07 Frost protection in cooling
mode No use
E19 1. Frost protection function
active Outdoor temperature and
pool water to cold Switch off machine and make sure it
is safe from frost
E29 2. Frost protection function
active Outdoor temperature and
pool water to cold Maschine abschalten und
Frostsicherheit herstellen
E08 Data connection display
electronics board Data line interrupted Check signal cable connection
The error codes below can be caused by a defective part, tripping of the safety devices or incorrect use.