9
www.aquascapeinc.com |
☎
CAN 1-866-766-3426 |
☎
US 1-866-877-6637
STEP 13
BUILD THE WATERFALL
• Position your waterfall so it
is facing the main viewing
areas.
• Build waterfall and stream
approximately 3’ from
the AquaBlox
®
, providing
enough liner at the top of
the waterfall to wrap over
the top of the Waterfall
Spillway.
• Tamp the ground under the desired location for Waterfalll
Spillway to provide a flat level surface.
• Set the Waterfall Spillway into place.
• Pull your underlayment and liner into place.
• You can adjust the height of the Waterfall Spillway by
adding gravel underneath the Spillway (on top of the liner)
until you have reached your desired height.
• The gravel will also provide a suitable base for leveling the
Waterfall Spillway.
STEP 14
HOOK UP AND LEVEL THE WATERFALL SPILLWAY
• Fold liner over top of Waterfall
Spillway. It is recommended
to provide some slack in the
liner in case the position of
the Waterfall Spillway needs
minor adjustment during
installation.
• Use a screw driver or awl,
puncture a small hole in the
liner through the center of the
Waterfall Spillway bulkhead.
This will be your reference
point for the location of the
liner connection.
• The Waterfall Spillway
should be level from side
to side and tilt forward a
¼ bubble on a 2' level.
• Place two larger
boulders on either side
of the waterfalls you
are creating in order to
“frame” the waterfalls.
The water will be running between the two larger boulders
you’ve set in place.
• You can now begin to stack the rocks between the two
larger boulders. These are the rocks that the water will be
running over, so take your time and be creative. Start with
the larger rocks on the bottom and work your way up to
the smaller ones on top.
• Small stones and gravel can be used to fill in the gaps
between the larger waterfalls stones.
• The built-in water level
inspection port allows
the lid of the Pondless
®
Waterfall Vault to be
buried just below the
surface of the rock.
Instructions continued on next page.