2
USE & CARE
2
INSTALLATION STEPS
3
Use and Care
• To clean your system, wipe down the
exterior with a damp cloth.
• Do not use any strong or abrasive
cleaning agent or solvent cleaner.
Tools Recommended for
Installation:
• Variable Speed Drill w/ 7/32" Bit
• Adjustable Wrench
• Philips Head Screwdriver
• Level
• Pencil
• Measuring Tape
• Bucket
• Hammer
• Safety Glasses
Important Safeguards
• Do not install this system where the
line pressure may exceed 80 psi. The
operating pressure range for this
filter is between 20-80 psi.
• Install on COLD water lines only
(40° - 90°F).
• Use caution when installing the
system manifold on a cabinet wall
that backs up to a dishwasher.
Screws may exceed cabinet width.
• It is recommended that your system
be installed inside and out of direct
sunlight. The system must be
protected from both direct sunlight
and freezing temperatures.
• Filter usage must comply with all
state and local laws.
• Do not operate without the
filters installed.
• The filter housing must be replaced
every five years. Failure to do so
could result in potential leaks due
to product deterioration. To order,
please call Customer Support at 866-
662-6885.
• Do not use with water that is
microbiologically unsafe or of
unknown water quality without
adequate disinfection before or after
the system.
• Systems certified for cyst reduction
may be used on disinfected waters
that may contain filterable cysts.
This system requires an existing faucet hole at least 1/2" (13mm) in diameter
in the sink or countertop to install the supplied dedicated faucet. You may also
replace an existing kitchen sink sprayer, soap dispenser, or pre-existing hole on
the sink or countertop.
Attach Brass Tee and Tubing
A. Attach threaded ends of brass tee to the
cold water supply line and shut-off valve.
Tighten with wrench.
B. Attach white tubing to brass tee by sliding
the compression nut onto white tubing
with threads of the nut facing the end of
the white tube.
C. Slide plastic sleeve onto the white tube.
Place brass tee insert into the opening of
the white tube. Push the tip of the white
tubing into the opening of the brass tee.
While holding the white tube in place,
tighten the compression nut to compress
the plastic sleeve and create a seal.
1
2
If you elect to drill a new hole for the dedicated faucet installation, we strongly
recommend consulting a professional. Please wear safety glasses when drilling.
Please read all precautions and instructions carefully before using.
Setup
A. Unpack and unwrap box contents.
B. Turn off the cold water supply. Turn on
the kitchen faucet to release pressure
and allow water to drain from the line.
C. Disconnect the cold water supply using
a wrench.
B
C
A
B
A
B
C
AQ-5200
Scan to view AQ-5200 product
and installation videos.
AQ-5300
Scan to view AQ-5300 product
and installation videos.
AQ-5300+
Scan to view AQ-5300+ product
and installation videos.
