3
3. INTRODUCTION
Aquaphor RO-31 (further referred to as “RO”) manufactured by Aquaphor Corporation.
RO is designed for drinking water post-treatment from mechanical and colloidal particles, organic
impurities, bacteria, hard water components and other objectionable water impurities. RO eliminates
unwanted odors, flavors and discoloration of water, supplied by municipal and local water networks (water
from artesian water sources, wells, etc.), when meeting the requirements of this manual. RO materials are
safe, non-toxic and do not exude substances dangerous to human health and the environment.
4. DMW MAIN BLOCKS AND OPERATION PRINCIPLES
Collector blocks consist of housing, with three collectors fixed onto it, to replace the replacement cartridges.
Automatic valves have holes for wall mounting (fig. 1).
3
4
1
2
5
Figure 1
The water treatment block (1)
pre-purifies and prepares the water for the membrane separation stage. This
block includes the replacement cartridge К5 (installed in the first position according to the water flow path) and
replacement cartridge К2 (installed in the second position). The preliminary water treatment block purifies water
from mechanical impurities, active chlorine, oil by-products, phenols, pesticides, chloroform and heavy metals.
Membrane cartridge (2).
Here, water divides into two streams: purified water, ready for further treatment
and drain water, which includes unwanted impurities.
Clean water storage tank (3).
When connecting the tip to the storage tank water will begin filling
the tank. After filling the tank, the float will rise and the water supply is automatically switched off and the
tip disconnects. If it is necessary to stop water filling earlier, just push the button located on the top of
the upper lid.
Web clipper (4).
Designed for automatic water supplying disconnecting.
Water conditioning cartridge (5).
Water conditioning cartridge (further referred to as “conditioning
cartridge”) Aquaphor is designed for the correction of acidity (pH) and to enrich the water minerals to improve
the flavor and adjustments of the salt balance of drinking water.
5. RO* INSTALLATION
ATTENTION! To install, we recommend contacting our customer service department or an available
regional Aquaphor dealer.
ATTENTION! Before installation it is necessary to measure the incoming water pressure to your home.
If it exceeds 0,63 MPa (6,3 bar or 91.4 psi), install a pressure regulator with the waste-free operation
* Depending on the amount of impurities in the water, the service life (resource) of the water treatment cartridges may vary
(may be shorter or longer than the standard service life).
