aquanique PC UVC 9 W, Руководство по эксплуатации

Страница: 14 / 41

- EN -
14
Cleaning the quartz glass / Replacing the UVC lamp
Replace the UVC lamp after max. 8,000 operating hours. This ensures optimum filtering performance.
C A U T I O N
Quartz glass and UVC lamp can break and cause cut injuries.
•
Handle the quartz glass and UVC lamp with care.
Prerequisite
•
The unit head is removed.
(→ Dismantling the unit head)
•
Ensure that the identification and capacity data of the UVC lamps used correspond to the information on the unit type
plate.
(→ Technical data)
How to proceed:

G
1. Loosen the self-tapping screw until the the screw tip is sunk in the housing of the clamping screw.
2. Unscrew the clamping screw counter-clockwise.
3. Remove the quartz glass including the O ring towards the front with a slight turning movement.
4. Pull out the UVC lamp and replace.
5. Push the quartz glass including the O ring as far as the stop in the unit head.
– Clean the O ring, replace if damaged.
– Ensure that the O ring is located in the gap between the unit head and the quartz glass.
6. Tighten the clamping screw clockwise up to the stop.
7. Tighten the self-tapping screw.
8. Wipe the quartz glass tube with a damp cloth
9. On completion of the work, fit the unit head.
(→ Fitting the unit head)
Wear parts
•
UVC lamp, quartz glass and O ring for quartz glass
Disposal
N O T E
Do not dispose of this unit with domestic waste.
•
Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system
provided for this purpose.
Technical data
Description Clarifier 9W
Rated voltage V AC 230
Mains frequency Hz 50
Power consumption W 12
Protection type IP24
Permissible water temperature °C +4 … +35
UVC lamp Type 9 W TC-S (UV-C)
Recommended max. flow rate l/h
≤
1700
Operating pressure Max. bar 0.5
Dimensions Length mm 330
Width mm 120
Height mm 100
Weight kg 1.4