background image

Care and Maintenance

1)  While your product has been initially treated with UV protectant, long-term 

exposure to sunlight will damage the product. Regularly apply a UV protec

-

tant to the exposed surface of the tube to ensure the life of your product. We 

recommend using ONLY 303 UV Protectant intended for use on vinyl for this 

purpose.  Monthly application while the product is in use is required.  

NOT 

DOING THIS WILL VOID THE WARRANTY. 

303 UV Protectant is 

available at most watersports dealers, or online at www.303-products.com.

2)  

WARNING:

 Certain products, especially petroleum-based solvents, clean

-

ers and protectants such as ArmorAll can damage the product and use of 

these products will void the warranty. 

3)  

WARNING:

 Use of a high-pressure washer will damage the product and 

void the warranty. To clean, use a soft bristle brush with mild soap and fresh 

water. 303 UV Protectant contains a ‘safe for vinyl’ cleaner, and can be used 

to clean and protect the product at the same time. 

4)  Check the inflation of your tube often. Check for proper air pressure using 

a manometer.  It may appear to have lost air early in the morning, but will 

expand once the sun warms it.  Maximum expansion will occur in the heat of 

the day.  Under-inflation can cause absasion and premature wear.  Proper 

inflation will discourage marine animals from chewing the product and 

prevent premature damage from wear.

Storage

1)  Before storing, place the product on a clean, level area.  Clean with mild 

soap and water and allow to dry completely.  Apply 303 Protectant to the 

surface of the Splashmat before deflating.  

2) Remove ALL of the air from the tube using the deflation end of the high output 

inflator/deflator. 

3) Fold the deflated product in thirds then roll loosely.
4) Store the product out of direct sunlight and protected from the environment in 

a clean, dry location. It is best to store inside a container with moth balls to 

prevent damage from rodents. NEVER store uncovered, in a damp location, 

or on concrete surface! NEVER store at temperatures below 40 degrees F.

Splashmat in Use as a Stand-Alone Item

Aquaglide, Inc.    #1 North Shore Dr, SE    White Salmon, WA  98672      TEL: (509) 493-4938      FAX: (509) 493-4966

www.Aquaglide.net

A

B

C

1

3

2

4

5

Interloc Strap Instructions

Splashmat Attached to Aquapark

Twist Stem to Open or Close 1-Way Valve

Содержание Splashmat








Отзывы: