4
1. Do not attempt repairs by yourself. Do not try to repair a chiller that was
damaged in shipment or damaged during use. Contact the manufacturer or your
retailer in the event of malfunction.
2. Unplug chiller before putting on or taking off parts, before cleaning and when not
in use.
3. Do not submerge chiller in water.
4. Keep all connections dry and off the ground.
5. Do not touch electrical plug with wet hands to connect chiller to outlet.
6. Do not allow water or salt to come in contact with thermostat or power cords.
7. Do not allow electrical components to get wet. If electrical components get wet,
unplug the chiller immediately.
8. Do not operate the chiller if you smell smoke or there is burning.
9. Do not operate the chiller if cord or plug has been damaged in any way.
10. Do not operate chiller without water flow to the unit (evaporator housing may
freeze up and damage the chiller).
11. Properly connect chiller to a three-pronged grounded outlet.
12. Connect chiller to a ground fault circuit interrupter (GFCI).
13. Only 115v (60Hz) electrical source should be used with chiller.
14. Leave a drip loop in the power cord to prevent water from running the length of
the power cord and reaching the power outlet.
15. Do not use extension cords.
16. Do not expose chiller to outside elements.
17. Use only manufacturer’s genuine replacement parts. The manufacturer is not
responsible for hazards caused by the use of unauthorized parts.
18. Keep a copy of this instruction sheet for reference.
MAINTENANCE
Warning:
Do not touch chiller, cord or electrical plug with wet hands. Disconnect
chiller from electricity (power supply) before performing maintenance, moving or
adjusting chiller.
Every Month:
1. Remove grill, clean dust and debris away with vacuum or a jet of air.
2. Clean the dusk cover.
3. Check water pump and filter supplying water to chiller to ensure good water flow.
4. Clean the heat exchanger with clean water.
Every 6 Months:
1. Clean filter pad, rinse filter with clean water to remove deposits, bacteria and
impurities captured by the filter. Air dry filter pad before replacing.
2. Use compressed air to clean debris and dust from the heat exchanger.
CAUTION:
•
Do not stack anything on top of chiller.
•
Place chiller unit in a well ventilated area.
•
Make sure the ambient temperature does not exceed 95
˚
Fahrenheit.
•
Do not use a pump with more than 20 feet of head pressure rating.
.
