AquaCraft Rio 51Z Скачать руководство пользователя страница 3

3

WARRANTY & SERVICE

ENGINE WARRANTY SERVICE

Aquacraft will warrant your G260PUM engine for 90 days after 
purchase from defects in materials or workmanship of original 
manufacture. Aquacraft, at their option, will repair or replace at 
no charge the incorrectly made part. This warranty does not cover 
damage caused by crash, abuse, or misuse. To return your engine for 
repairs you will need to provide proof of purchase, such as your store 
receipt or an invoice. Send the engine to the address listed below or 
see the ZENOAH owner’s manual for other warranty information.

BOAT WARRANTY SERVICE

AquaCraft will warrant your Rio 51Z for 90 days after purchase 
from defects in materials or workmanship of original manufacture. 
AquaCraft, at their option, will repair or replace at no charge the 
incorrectly made part. This warranty does not cover damage caused 
by crash, abuse, misuse, alteration or accident. To return your boat 
for repairs you need to provide proof of purchase. Your store receipt 
or product invoice will suffi ce.

IN NO EVENT SHALL THE PURCHASER BE ENTITLED TO ANY 
INCIDENTAL, SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES, 
WHETHER RESULTING FROM THE USE, MISUSE OR INABILITY TO 
USE THE PRODUCT OR FROM DEFECTS IN THE PRODUCT. 

This warranty gives you specifi c legal rights and you may also have 
other rights, which vary from state to state.

Hobby Services 

3002 N. Apollo Drive, Suite 1

Champaign, Illinois 61822

Attn: Service Department

Phone: (217) 398-0007

9:00 am - 5:00 pm Central Time M-F

E-mail: 

[email protected]

•  

Gasoline is highly fl ammable. Keep it away from open fl ame, 
excessive heat, sources of sparks, or anything else that might 
ignite it. Do not smoke or allow anyone else to smoke in close 
proximity to open gasoline containers. Make sure that gas lines 
are in good condition so that gasoline will not leak onto a hot 
engine causing a fi re. 

•  

Never operate your engine in an enclosed space. Model engines, 
like automobile engines, exhaust deadly carbon monoxide. Run 
your engine only in an open area.

•  

R/C models produce vibrations which will cause screws, nuts, 
bolts, etc, on your model to become loose over time. It is important 
to make sure that all hardware is secure before operating your 
model.

•  

In the event that weeds become entangled in the propeller, stop the 
engine before attempting to remove them.

•  

If your Rio 51Z should happen to stall, water currents will slowly 
carry it to shore. The bad news is that the boat could be carried 
to the opposite shore. When surveying areas to run your Rio 51, 
keep variables in mind such as wind direction, size of the lake, etc. 
It is not advisable to run R/C boats on any free-fl owing bodies of 
water such as creeks or rivers.

•  

It’s a good idea to use eye protection when starting and running 
your Rio 51Z.

SPECIFICATIONS

RIO 51Z BOAT SPECIFICATIONS

51.5" long [130cm]
57" overall length [145cm]
13.5" beam [34cm]
8" tall [21cm]
13" overall height [33cm]
14 lbs, 4oz [6.4 Kilo]
26 oz fuel capacity [768cc]
20 minute run time per tank

ZENOAH

®

 G260PUM ENGINE SPECIFICATIONS

Stroke: 1.1 in [28mm]
Bore: 1.34 in [34mm]
Displacement: 26cc (1.58 cubic in)
Horsepower: 2.1
Ignition Style: Spark
Fuel: Gasoline/Oil mix 16:1
Weight: 3.75 lb [1.7K]

RADIO SPECIFICATIONS

Transmitter:  Tactic

 TTX240 with servo reversing and

dual rate functions

Receiver: Tactic TRX324
Servos:  Tactic TSX200 Throttle servo (56 oz-in at 6 volts)

Tactic TSX201 Steering servo (90 oz-in at 6 volts)

Содержание Rio 51Z

















Отзывы: