4
ASSEMBLE THE STAND
1. Insert the wire uprights into the base of the boat stand as
shown in the photo (note direction).
2. Tighten the two (2) thumb screws fi rmly.
TRANSMITTER
The transmitter is not water resistant and should never come
in contact with water.
Slide off the battery door on the back of the transmitter. Install
4 fresh “AA” batteries into the transmitter in the confi guration
molded into the battery compartment. Re-install the battery
door onto the back of the transmitter.
Sail Control Stick
LED
On/Off Switch
Rudder
Control Stick
Rudder
Control Trim
Sail Control Trim
Turn the transmitter on using the switch on the front. The red
LED should light up. If it does not light up, turn the transmitter
off and check to make sure that the batteries are installed
properly. If you see a fl ashing red LED, the batteries are low
and need to be replaced.
Carefully remove your Paradise sailboat and all remaining components
from the box.
IMPORTANT:
Use additional care not to bend the mast
while removing the mast and sail assembly from the box.
