Order #
Item
Description
HCAB7760 3-Blade Propeller
One propeller with one
locknut
HCAB7853 Drive System
Stuffing tube and drive
shaft, prop coupler
(drivedog)
HCAB7854 Motor Coupler
One coupler with two
3x3mm set screws
HCAB8706 Rudder & Parts
Rudder, rudder control
arm, rudder metal standoff,
screw to secure arm
Order #
Item
Description
HCAB8801 Deck Accessory Set 2 life preservers, 2 fire
extinguishers, radar
antenna and lightning
rod, lifeboat, 2 bumper
tires with mounting string
and one deck ladder
HCAM7037 ESC (For/Rev)
ESC includes exact wiring
as the ESC included with
boat. (motor wire with
plugs, battery wire with
plug, receiver wire plug
and switch)
HCAG1060 550 Electric Motor Motor wire with plugs and
capacitors installed
6
To order replacement parts for the AquaCraft Atlantic Harbor Tugboat, use the order numbers in the
Replacement Parts List
that
follows. Replacement parts are available only as listed and can be purchased from hobby shops or mail order/ Internet order firms.
Hardware items (screws, nuts, bolts) are also available from these outlets. If you need assistance locating a dealer to purchase
parts, visit
www.aquacraftmodels.com
and click on “Where to Buy”. If this kit is missing parts, contact
Product Support.
Replacement Parts List
ORDERING REPLACEMENT PARTS
LAUNCH PROCEDURE:
1. Turn the power “ON” to the transmitter and receiver (in
that order).
2. Gently place the boat in water that is at least 8" deep and
free of obstacles (weeds, rocks, sticks, ducks, muskrats, etc.).
3. Slowly advance the throttle to full speed and note if the
boat has a tendency to turn right or left. Adjust the steering
trim knob on your transmitter until the boat runs in a
straight line when the steering wheel is at neutral.
4. When finished running, be sure to turn the power “OFF” to
your boat and transmitter (in that order).
THE WAITING GAME
If your Atlantic Harbor Tugboat should happen to stall, wind
and/or water currents will
slowly
carry it to shore. The bad news
is that the boat could be carried to the opposite shore. When
surveying areas to run your boat, keep variables in mind such
as wind direction, size of the lake, strength of river currents,
etc.
Above all, NEVER attempt to swim after a stalled boat.
HELPFUL TIP:
Use a fishing rod with at least 12lb. line and a tennis ball tied
to the end to retrieve a stalled boat.
BASIC MAINTENANCE
When you are through operating your boat for the day, be sure
to perform these basic maintenance procedures. This will
prolong the life of the Atlantic Harbor Tugboat and help to ensure
trouble-free running.
Be sure to turn the power “OFF” to your
boat and transmitter before performing any maintenance.
• Remove the cabin.
• Remove the battery pack.
• Soak up any excess water with a paper towel.
• Make sure propeller and drive dog are free of moss and
other debris.
• Wipe down the entire boat with spray-on glass cleaner and
a paper towel.
• Allow the interior plenty of time to dry out before installing
the cabin for display.
GOOD LUCK AND GREAT BOATING!