Aquacal AutoPilot SP05, Руководство по установке

Страница: 20 / 89

Page - 16
3. Confirm that the filters leading to the heat pump are clean.
4. Adjust the valves controlling water headed towards the heat pump to the half-open position.
5. Adjust the valves controlling water leading away from the heat pump to a fully open position.
6. Activate the pool water filtration pump.
7. Slowly raise the thermostat temperature until the heat pump activates.
l
The source-water filtration pump will cycle on first.
l
After a three-minute delay, the heat pump's compressor will start.
8. With the heat pump running, confirm the source-side water filtration pump is operating properly with adequate
flow and no short cycling.
9. Wait for water temperatures to stabilize (approximately 5 minutes).
10. Open the temperatures differences screen in the Geothermal Menus. See " Geothermal Menus " on the facing
page.
12. Adjust valves in the following order using the temperature
chart provided.
a. Adjust the source-side valve on the heat pump outlet
until the correct temperature differential is achieved.
b. Adjust the pool-side valve that controls water exiting the
heat pump until the correct temperature differential is
achieved.
c. Wait for water temperatures to stabilize. Then check the source-side temperature again. Re-adjust the valve as
needed.
13. Mark valves at these positions for future reference.
HEAT EXCHANGER
TYPE
MODEL SOURCE-SIDE POOL-SIDE
Titanium pool-side and
source-side exchangers
WS03
1° to 5° F
(.5° C to 2.8° C)
2° to 4° F
(1.1° C to 2.2° C)
WS05
2° to 8° F
(1.1° C to 4.4° C)
3° to 6° F
(1.7° C to 3.3° C)
WS10
5° to 12° F
(2.8° C to 6.7° C)
6° to 14° F
(3.3° C to 7.8° C)
Titanium pool-side
exchanger and
cupronickel source-side
exchanger
WS03
6° to 8° F
(3.3° C to 4.4° C)
1° to 3° F
(.5° C to 1.7° C)
WS05
7° to 13° F
(3.9° C to 7.2° C)
2° to 6° F
(1.1° C to 3.3° C)
WS10
6° to 11° F
(3.3° C to 6.1° C)
6° to 14° F
(3.3° C to 7.8° C)
Table 1 - Temperature Chart (Water Source)
1
-
Ins
ta
ll
at
ion