Aqua Premium 200, Инструкция по установке и эксплуатации

Страница: 34 / 65

●
Then press "START". The robot starts the new cleaning cycle.
3.5. Starting a second cleaning cycle
If a second cleaning cycle should be required, switch off the power supply for 5
seconds, by pressing "0", and restart the robot (position "I"). Then follow step 3.3.5.
3.6. Stopping the robot and putting it away
●
Once the cycle is complete, switch off the power supply (position "0").
●
Leave the robot in the pool for 15 to 20 minutes to allow the motor to cool
down.
●
Bring the robot to the shallowest part of the pool by pulling very gently on
the cable until the device reaches the surface.
●
Lift it out of the water using the handles, but NOT the cable.
●
When pulling the cable, reel it in hand-over-hand, do not reel it around your
arm. Make sure that the cable is always straight, not twisted.
11