Aqua DGTEC CD, Инструкция по эксплуатации и техническому обслуживанию

Страница: 16 / 36

ADSP7000634 rev. 1.3 23/09/2020 16/36
To go back to the main Con entry of the Programming Menu, press Enter for 3 seconds.
The applied pressure for 3 seconds to set the Set-point, from the reading entry, assumes that the g/l of optimal
detergent has been dissolved in the tank to carry out the wash.
Fig. 13 - Set-point and measured reading value setting from the Programming Menu
3.3.3
D
ISPLAYING AND
R
ESETTING
S
TATISTICS
From the StA entry on the Programming Menu you can access the Pump statistics submenu.
Here below are the parameters saved during the pump's operation:

The pump's overall operating time t.F.P , from 0 to 999 hours, with the following format:
- h.mm up to 9 h and 59 m
- hh.m up to 99 h and 59 m (minutes expressed in tens)
- hhh up to 999 h

Number of times the OFA 1 over-dosage alarm has been activated, indicated by OF1 (from 0 to 999);

Number of times the OFA 2 over-dosage alarm has been activated, indicated by OF2 (from 0 to 999);
To reset each of the above-mentioned fields, just access from the numerical value to the
rSt reset entry with the F
key and from there select YES , confirming with Enter : the corresponding reset value is displayed.
Fig. 14- Statistics Menu
To go back to the Programming Menu press Enter for 3 seconds.