7
USER MANUAL FOR AC-2
6
POOL FILTER
during the set operation periods.
Set automatic operation periods:
Remark:
Before setting the automatic operation periods, set the water temperature lower than
the actual water temperature. Otherwise, the pump 1 will work all the time, and can’t
controlled by operation periods time. “A/M” key shows red light means the automatic mode;
“A/M” key has no light means the manual mode.
Set the first operation period:
¾
Step 1:
Press “A/M” key to switch the pump 1 to the automatic mode (“A/M” key shows green).
¾
Step 2:
Set the start time: Press “T1” key, then press “A/M” key (The “A/M” key will lit, it means to
set the start time.), the hour/minute digit will be flashing. Press
“+”“-”
to adjust the hour/minute.
Press “T1” key again, the minute/hour digit will flashing, press
“+”“-”
to adjust the minute/hour. No
action within 5 seconds, the start time will be stored automatically.
¾
Step 3:
Set the end time: Press “T1” key, then press “A/M” key (The “A/M” key has no light, it
means to set the end time.), the hour/minute digit will be flashing. Press
“+”“-”
to adjust the
hour/minute. Press “T1” key again, the minute/hour digit will flashing, press
“+”“-”
to adjust the
minute/hour. No action within 5 seconds, the start time will be stored automatically.
PLEASE SET T2 AND T3 OPERATING PERIOD AS ABOVE OPERATION INSTRUCTIONS.
REMARK:
If it is no need to set the time in any of the 3 periods, just set the time to “00:00” in
that period to avoid it.
Cautions before first using:
Before running the device for the first time, turn on the ball valve of the pipe and fill water until the
equipment box pipe are full of water and then turn off the ball valve.
When it is ready to start running, press the
“ON/OFF”
key on control panel for several times until
the circulation pump can work normally because there may be some air inside the pipes and pump for
first runnin
g.
1.
Setting device running:
Manufacturer recommends
：
running time=water temperatur/2 (h)
For example
：
if water temperature is 24
0
C then the running time is 24/2=12hours
Recommending to set time as
：
8
：
00-20
：
00
The device can do filtering at night time if noise pollution is not considered.
