Page 3 of 11
QUICK START SUMMARY
1.
UNPACK
Carefully remove all packaging and put all parts in one safe place.
2.
IF ANY FAULTS OR PARTS MISSING
Check that you have received all required parts. In the unlikely event that some part is missing or the
water cooler is not working then please contact our Service Centre asap before you contact
Officeworks. AQUA TO GO contact details – ph 1300 760 474 or [email protected]
3.
REGISTER YOUR WARRANTY NOW
Please resister within 48hrs of purchase your product warranty at
4.
DISPENSE A CUP OF HOT WATER BEFORE YOU TURN ON POWER SWITCH
Dispense a cup of water from the red child safety hot tap prior to plugging into the power and turning
on the heating and cooling switches on the back of the cooler. Never leave switches on without a full
tank of water. To operate the red safety tap please read p5
5.
CHILL BOX AND COOLING CABINET
This is not a fridge but can be used to cool and keep cool foods and drinks where holding a stable
below 5
C temperature is not critical for food safety. Temperature will vary between -2
C to 15
C, is
effected by door opening, and is not adjustable.
6.
COOLER PLACEMENT
Place your water cooler in an area that is:
●
Has a room temperature less than 26
C.
●
Close to a power point. Do not, however, plug it in yet.
●
Out of significant direct sunlight and away from any heating appliance.
●
Well ventilated. Place cooler at least 10cm away from any wall.
●
Able to safely support the weight of the cooler with a bottle of water fitted.
●
Dust and dirt free. On the floor that can support the weight with bottle on.
●
Water safe for when usage drips occur or in the unlikely event of leakage (see p.5).
Note:
Never lift or carry your cooler by its taps or with bottle installed. Such action may damage the
taps and will void the product warranty.
7.
PRE RINSE
Your water cooler has been pre cleaned but the tank and water lines should be flushed. Gently twist
the spike anticlockwise and lift off the top cover. Slowly pour about 2 litres of fresh tap or spring water
into the tank and then empty this water into a large container using the red tap, then blue tap, then
white tap. Ensure the top cover is then properly secured back on - place into the slots, hold the spike
and gently twist clockwise. If the water dispensed has a bad taste then please refer to cleaning section
of this manual.
8.
INSTALLING A BOTTLE
Gently lower your AQUA TO GO water bottle onto the water intake spike. Please read any installation
instructions found on the bottle. Store all spare bottles in a cool place, out of direct sunlight.
.
9.
WATER TEMPERATURE
Let your water cooler run for 10 minutes to achieve optimal hot water temperature and 1 hour to
achieve optimal cold water temperature. Press the blue tap for cold water and the red tap for hot water.
Please also read, in particular, the following sections:
Cleaning (p.8), Troubleshooting (p.9), Limited Warranty (p.10), Customer Service Centre Contacts (p.10)
