accurately and allowing for the tubing to be run neatly in the
cupboard, as fixing clips are provided.
6 (d)
In the installation kit there is a Drain Connection fitting
(22). This fitting is like a 60mm hose clamp with a brass
fitting attached. This fitting must be fitted to the sink drain
pipe as close to the bottom of the sink or plug fitting as is
possible and as far away from the “P” trap as possible.
Identify a suitable location on the waste pipe, mark the pipe
through the hole of the brass fitting and drill a 4mm hole in
the drain pipe. Fit the Drain Connection fitting to the drain
pipe and ensure that the hole in the brass fitting is properly
aligned with the hole you drilled in the drain pipe. If the
contaminant water cannot drain freely, the Membrane will be
permanently damaged and any Warranty applicable to the
Membrane will be void. Tighten the clamp on the Drain
Connection so as to compress the rubber sealing washer to the
drain pipe and not leak. On the right hand end looking from
the front, of the Membrane Housing (8) there are two tube
connections. In the top connection there is a short piece
ofBLACK tube marked “CONTAMINANT WATER TO
DRAIN”. Remove this piece of tubing and replace it with the
BLACK tubing supplied, this is also marked
“CONTAMINANT WATER TO DRAIN”. One end of this
tubing has a label marked “IMPORTANT: THIS END MUST
BE CONNECTED TO THE MEMBRANE HOUSING”. This
end of the black tubing MUST replace the short piece of
BLACK tubing removed from the Membrane Housing. The
other end of this tubing connects to the Drain Connection
fitting (22) you have just fitted to the drain pipe. Measure the
length accurately allowing for the tubing to be run neatly in
the cupboard and at the Drain Connection end, allow for a
loop in the tubing so as the bend in this loop is above the
Drain Connection or the bottom of the sink by 100mm.
Fixing clips are provided. Remove the brass nut from the
Drain Connection fitting, being careful not to lose the brass
olive. Thread the nut and olive onto this end of the BLACK
tubing, push the tubing into the brass fitting, slide the olive
and locknut down, then tighten the locknut onto the brass
fitting on the Drain Connector.
6(e)
Turn the water supply on slowly, while holding or
locking the lever of the dedicated faucet (20) in the on
position (lift lever upward to lock on position) to release any
air trapped in the system. Check there are no leaks. Leave
like this until you have water trickling from the faucet, this
may take some time, possibly 20 minutes or more. Turn the
faucet off and turn the Water Storage Tank tap (24) on. The
purifier will now begin producing water into the Water
Storage Tank. Leave the purifier producing water into the
Storage Tank for as long as possible or for at least 3 hours.
Turn the water off using the Purifier Isolation Tap (16) on the
Multi Function Control Valve (17) and lock the lever on the
dedicated faucet in the on position to drain the Water Storage
Tank. When water ceases to flow from the dedicated faucet,
turn the Purifier Isolation Tap (16) on the Multi Function
Control Valve (17) to the on position, after a couple of
minutes, return the dedicated faucet lever to the off position.
The purifier is now producing water into the Water Storage
Tank. Leave the purifier producing water into the Water
Storage Tank for several hours, do not operate or draw water
from the faucet. After several hours the Water Storage Tank
will be full and the purified water will be ready for use.
6(f)
Check there are no leaks.
We recommend that you continue to
check for leaks for a day or so after installation.
29-APINSRO13212 (081)
Содержание APRO13212
Страница 7: ......
