Delivery Address:
PO Box 6767
Blacktown DC NSW 2148
Aqua-Pure
®
Water Filters
Reply Paid 6767
Blacktown NSW 2148
AP9250 Stage 1 Cartridge
3. Remove used stage 1 cartridge by turning it to the left. (Approximately 1/4 turn)
4. Hold cartridge fi rmly and pull downwards. (Be aware there will be
approximately 15ml / 1 tablespoon of water spill (ref fi g a).
5. Drain and dispose of the used cartridge.
6. Remove red plastic cover on new AP9250 stage 1 cartridge and
insert cartridge into the head cavity (ref fi g b).
7. Turn cartridge to the right, until it stops. (Approximately 1/4 turn)
AP9250 Stage 2 Cartridge
8. Remove used stage 2 cartridge by turning it to the left. (Approximately 1/4
turn)
9. Hold cartridge fi rmly and pull downwards. Be aware there will
be approximately 15ml / 1 tablespoon of water spill (ref fi g c).
10. Drain and dispose of the used cartridge.
11. Remove red plastic cover on new AP9250 stage 2 cartridge and
insert cartridge into the head cavity (ref fi g d).
12. Turn cartridge to the right, until it stops. (Approximately 1/4 turn)
13. Slowly turn water supply on. Leave fi lter tap at ON position and allow water to
run for a minute to fl ush the new cartridge.
14. Reset the LCD fi lter monitoring system.
a.
b.
c.
d.
GUIDE TO REPLACE YOUR CARTRIDGE
The Aqua-Pure
®
AP9200
+
series Twin NEP head has auto shut off feature and is designed for your safety. NEP head’s auto shut off feature safeguards against human error
such as accidental removal of cartridge when water supply is not isolated.
In the event that the cartridge is removed without isolating water supply, the auto shut off head mechanism will terminate the incoming water supply and vent off residual
water pressure through the drain tube. Approximately 50ml / 3 tablespoons of water will drain from the tube.
While this feature is built into every single NEP head, Aqua-Pure
®
recommends water supply to be isolated and pressure relieved prior to cartridge change before proceeding
with cartridge replacement as per steps below.
1. Turn water supply off. If there is no isolation tap, turn off mains water supply.
2. Turn fi lter tap on to check water supply is off and to release any residual water. Leave fi lter tap in ON position.
NOTE:
Aqua-Pure
®
fi lter systems are designed for ease of installation. However, post-installation inspections are highly recommended. Check for leaks immediately after installation and once
again after 24 hours. If leaks are detected, turn off water supply, drain water and inspect the leaks. If problem persists, contact the installer/ plumber for rectifi cation.
