7. After adjusting the fi lter tap to face the desired direction, tighten the hex nut with
a padded adjustable wrench or spanner.
AP9200
+
FILTER SYSTEM HEAD
AP9250 Stage 1
Filter Cartridge
AP9250 Stage 2
Filter Cartridge
AP9250 Stage 1
Filter Head
Water Inlet
Water Outlet
Pressure Relief Outlet
LCD Display
Battery Cover
Shroud
LCD Display
Activation Button
Mounting Bracket
AP9250 Stage 2
Filter Head
CONNECTING THE LCD FILTER MONITORING
SYSTEM
1. Connect the black connector (light indicator wire) to the black connector on the
shroud.
2. Connect the white connector (capacity / time indicator wire) on the bracket to the
white connector on the shroud.
3. Slide the shroud onto the bracket as shown in the
direction of the arrow (ref fi g 22 and 23).
fi g. 22
fi g. 23
ACTIVATION AND RE-SETTING OF LCD
FILTER MONITORING SYSTEM ON SHROUD
The monitoring system is operated by two
buttons (F1 and F2) for system start-up after
initial installation and subsequent re-setting after
each fi lter cartridge change-out (ref fi g 24).
fi g. 24
1. Remove battery cover.
2. F1 button - After installation of your new AP9200
+
system or after replacing any
of the two fi lter cartridges, press F1 button and hold for at least 4 seconds. The
LCD display on the left side of the monitor will light up all 12 bars and you will hear
one long buzz followed by three short buzzes.
3. F2 button - After installation of your new AP9200
+
or after replacing any of the
two fi lter cartridges, press F2 button and hold for atleast 4 seconds. The LCD
display on the right side of the monitor will light up all 12 bars and you will hear
one long buzz followed by three short buzzes.
NOTE
: The sequence in which the F1 and F2 buttons are activated is not important and will not
affect the performance of the monitoring system.
The left column of the LCD display indicates a time (months) based monitor and the right side
LCD indicates a capacity (gallons/litres) based monitor.
When either of the displays is left with one lighted bar, the drinking water fi lter tap light indicator
will turn from blue to red, indicating that the fi lter cartridge should be changed. When this last
lighted bar is depleted, the audio alarm will be activated 2 seconds after the drinking fi lter tap
is turned on each time. The alarm will remain activated for a period of 10 seconds until the fi lter
cartridges are changed and the monitoring system re-set.
4. To click the status of the fi lter system, press the “push” button on the LCD
display control panel (ref fi g 25).
5. From underneath sink, slide the white wire holder through the 1/4” blue tubing
and threaded brass stem. The light indicator wire should be threaded through the
side hole of the white wire holder.
6. Slide in the star washer and hex nut onto the threaded brass stem and tighten by
hand (ref fi g 18).
NOTE:
For correct installation, please refer to fi g 18.
Filter Tap
LED Indicator Ring
Rubber Gasket
Bench Top / Sink
Wire Holder
Star Washer
Hex Nut
Light Indicator Wire
(To shroud cover)
Filter Tap Tube
1/4” Tube Connector
fi g. 18
BATTERY INSTALLATION
1. Slide the battery cover out (ref fi g 19).
fi g. 19
2. Lift the battery cover (ref fi g 20).
fi g. 20
3. Install three AA size alkaline batteries (use only alkaline battery)
4. Place the cover back (ref fi g 21).
fi g. 21
fi g. 25
