6
Operating Instructions - Wireless Mode
Switch the light unit to wireless mode using the instructions
on the previous page.
Auto mode allows the user to set the light unit to automatically
switch on and off as well as increase and decrease intensity
between different time points. Auto mode can be used to
replicate a natural lighting cycle, including sunrise/sunset,
moonlight and cloud cover.
Manual mode allows the user to adjust the intensity of the
blue and white channels independently to suit specific
requirements.
NOTE:
Whilst in manual mode, functions such as timer,
moonlight and clouds will not function.
Numbered steps on this page refer to the numbers on the
settings menu.
AUTO MODE
The light unit comes with factory default settings that allow the
light unit to be used without any changes in settings as long
as the time and date are set. Changes to any or all settings
can be made as follows:
Enter the menu by pressing the MODE button for 3 seconds.
1. Time: Set the time and date.
Using the LUM+/LUM- buttons, set the hour. Press ok to move
to the next number. Repeat until the time and date are set.
Time points
The default time points are as follows:
2. White Intensity. The time point will display a time and a
percentage, this is the white light intensity at that time. Select
the time by hour, press OK, select the minutes, press OK,
select the intensity and press OK again. Select an intensity
for each of the 10 white time points.
3. As above but fot setting blue time points.
The following diagram shows the light intensity profile over
24 hours of 1 channel (white or blue) and shows how the light
shifts between time points.
4. Light compensate: In light compensation mode, the degree
of compensation can be adjusted. The value can be adjusted
from 1-10. Higher values will increase the amount the intensity
rises or falls relative to the ambient light.
Default Value = 5
5. Cloudy: Adjust the amount of cloudy days. 0 = low number
of cloudy days, 5 = regular cloudy days.
Default value = 0
6. Moonlight: Adjust the maximum intensity of moonlight. (0-
30%)
Default value = 15%
To remove the moonlight feature, set the moonlight value to
0.
7. B-W Select: Set the relative ratio for colour in auto mode.
0 = blue and white at equal intensity (default value)
1 = blue 100%, white at selected ratio
2 = white 100%, blue at selected ratio
8. B-W Ratio: Select the ratio when B-W select has a value
of 1 or 2.
Selecting a value of 90 will make the white:blue ratio 90:100
when B-W Select value is 1 and vice versa when the value
is 2.
Default value = 100
9. Back to Default: Reset all values to default.
MANUAL MODE
1. To set the time and date refer to AUTO MODE
instructions.
Press MODE to bring up Manual W on the display. Use the
LUM+ and LUM- buttons to select the desired white intensity.
Press MODE again to bring up Manual B on the display.
Use the LUM+ and LUM- buttons to select the desired blue
intensity. Leave the display in Manual mode (displaying either
Manual W or Manual B).
