5
Use the Function keys as described below.
PWR - Light unit and wireless controller
Power button. Switch the unit on/off by pressing the
PWR button for 3 seconds. The light unit will power up
to the programmed intensity or power down rather than
switching immediately on or off, this is to reduce wear
on the LEDs and extend the life of the unit.
Press the power button to activate the control panel
display. The display switches off after 90 seconds of
inactivity.
LUM+ / LUM- - Light unit and wireless
controller
Increase/decrease the light intensity in manual mode.
Scroll up/down in menus.
SRC - Light unit and wireless controller
(PWR & SRC key on light unit)
Switch between white only, blue only and white + blue.
MODE - Wireless controller only
Switch between auto and manual mode.
Manual W allows the white intensity to be adjusted,
Manual B allows the blue intensity to be adjusted.
COMP - Wireless controller only
Switch light compensation on/off. Light compensation
mode allows the unit to dim based on ambient light
conditions to save power. In a brightly lit room, the unit
will dim so that the aquarium still recieves the same
amount of light. In a poorly lit room, the intensity will
increase.
OK - Wireless controller only
Select option from menu.
Save settings and return to menu.
ESC - Wireless controller only
Exit the menu.
Function Keys
Operating Instructions
The light unit can be directly operated in manual mode
which allows manual adjustment of both the white and
blue dimming channels.
Switch the unit on by pressing and holding the PWR &
SRC button for 3 seconds. This will initiate Auto mode.
Without a wireless controller, auto mode has default
time points to create a sunrise/sunset. The unit will
default to 06:00 when the light unit is powered on so
the default times will be adjusted based on when the
light is switched on.
Press the PWR button once and the unit will enter
manual mode. The intensity of the white LEDs can be
set using the LUM+ and LUM- buttons. Press the PWK
button again and the intensity of the blue LEDs can be
set using the LUM+ and LUM- buttons.
Press the PWR button again and the white and blue
LEDs will power on at the intensities set above.
Press the PWR button and the light will flash 3 times.
This indicates the unit is in wireless mode and can
be controlled using the wireless controller. Operating
instructions for the wireless controller can be found on
the following page.
Press the PWR button again and the unit will flash 4
times and enter auto mode.
Pressing and holding the PWR button will turn the light
unit off.
NOTE:
Auto mode without a wireless connection
is different to the Auto mode set with the wireless
controller.
