Aqua One Aquatica 160, Инструкция по эксплуатации

Страница: 6 / 12

6
Gently pour the gravel into the aquarium and
spread it out by hand.
6. Unpack the Filter Pump, Elbow, Duckbill and
Riser Hose. Attach the hose to the Elbow and
Pump.
7. Lower the pump into the filter chamber. Push
the open end of the elbow into the return hole
and attach the duckbill to the elbow through the
other side.
8. Rinse the Media Baskets in clean tap water.
Move the baskets around in the water to ensure
that all of the media has been rinsed. Place
them into the filter chamber as shown.
Setup Instructions
Please check that all parts and equipment are
present and not damaged before setting up your
aquarium.
It is a good idea to rinse any ornaments in
clean water before using in an aquarium.
For advice on how to treat natural materials,
seek advice from your aquarium specialist.
All equipment and accessories should only
be used for the aquarium and should be
purchased specifically for aquarium use.
Do not use any chemicals or detergents to
clean anything intended for the aquarium.
1. Consider where you are going to place the
aquarium. Keep it away from direct light or areas
with large temperature fluctuations.
2. Assemble cabinet according to instructions
supplied with the cabinet.
3. Place the cabinet on a level surface strong
enough to support the weight of all equipment.
Note that water is heavy (1kg per litre) – the
complete aquarium may weigh more than 250kg
when set up.
4. Unpack the aquarium and place onto the
cabinet. Using a clean, damp cloth, wipe the
inside of the aquarium to remove any dust.
DO NOT USE ANY CHEMICALS OR
DETERGENTS
5. Rinse gravel (sold separately) with tap water in
a clean bucket.
To do this, place a small amount in the bucket
and rinse under the tap or with a garden hose.
Use one hand to churn the gravel over until the
water runs off clear.