7
Fig. 2: pump
3. Dimensions
Dimensions of the filter housing:
-
Height: 26 cm, approx. 10.5“
-
Width: 16 cm, approx. 6.4“ (total), 9 cm c. 3.6“ (outside)
-
Lenght: 27,5 cm, approx. 10.8“
4. Installation
-
Set up of the pump:
-
The unit consisting of pre-filter (7), suction nozzle (12) and pump (8) lies straight on the
bottom of the filter housing. Take care that the clip of the lid shows downwards and that the
pump is located at the side of the water in- and outlet. You can recognize this side from the
2 half-openings for the pipes.
-
Set up of the filter housing
After positioning the pump, the 2 holding clamps (3) are mounted. Depending on the width
of the aquarium glass or frame, either the first or second slit in the housing is used for the
clamp. The filter housing is now hanged outside of the aquarium, but by turning the claps
around, it can also be used inside. Aquaria with plastic cover need a gap like shown in the
drawing below. The gap can be sawn out.
8. Motor
17. Rubber bearing
18. Rotor (magnet
and impeller)
19. Ceramic shaft
20. Pump head
