*
The applied power source must be the 12V DC power source (as Figure 4).
*
Do not block the inflation inlet
①
and deflation outlet
②
, and ensure that the
inflation inlet
①
and deflation outlet
②
shall remain smooth at all times.
*
Observe the local waste treatment provisions, and it is not allowed to throw
the air pump away randomly.
*
Don't use this product when the hose is damaged.
*
Don't pull out the hose when inflating, because
the high pressure may hurt you.
*
Don't keep the air pump working for more than 20
mins, because motor overheating may
cause internal damage. The air pump shall
be fully cooled for 30 mins after continuously
working up to 20 mins.
* Notice: The factory default setting air pressure is 10PSI (10PSI=0.689BAR).
From the second-time use, the default air pressure will be the value you set
in last time.
* Notice: When the air pump is powered on and without any operation over 2
minutes, it will enter standby mode. You can press any key to re-activate the
pump.
* Remove the hose from the inflation inlet and connect it to the deflation outlet
②
, twist clockwise to tighten it, as Figure 3.
* Press the On/Off button to start the deflation. Press the On/Off button
again to stop the deflation.
6
VI. Precautions
V. Deflation operation
（
Figure 4
）
（Figure 3）
