Revised 2/28/18
Copyright © 2018 Aqua Creek Products All Rights Reserved
3. Orient the pull out legrest as shown below and slide the plastic guide/spacer into the chair support
tube. Tap the palstic guide/spacer with a hammer or mallet until fl ush with the end of the support
tube. The threaded hole in the bottom of the plastic guide/spacer should line up with the hole
drilled in the support tube. Install the washers and 1/4”-20 x 1/2” cap screw from underneath and
tighten until snug.
1" SQ. TUBE
PLASTIC
GUIDE/SPACER
PULL OUT LEGREST
1/4" FLAT WASHER
1/4" LOCK WASHER
1/4" X 1/2" CAP SCREW
CHAIR SUPPORT TUBE
PLASTIC GUIDE/SPACER
FLUSH WITH 2" SQ. TUBE
The PULL-OUT LEGREST is now ready to use. However, before using, slide the legrest in and out, and put
the pad up and down to make sure everything works smoothly.
LEGREST
STOWED
LEGREST
OUT
LEGREST
OUT & UP
SLOT
PIN
SLIDE FORWARD AND INSERT PIN TO LOCK IN "UP" POSITION
3
