Copyright © 2019 Aqua Creek Products All Rights Reserved
Revised 6/17/19
1.
Attach seat belt to the seat.
SEE FIGURE 7
2.
Install the Ambassador pool lift onto the three (3)
anchors using the supplied 1/2 inch x 1 1/2 inches
stainless steel hex-head bolts and 1/2 inch stainless steel
washers. Make sure all bolts are tight before using the
lift.
SEE FIGURE 8
3.
Apply dielectric grease to the plug terminals,
including the o-ring seal. Plug the handset cable into the
large handset socket on the bottom of the control box.
Press the cord end fi rmly into the socket until you are
sure it is completely in the socket. Failure to fully push
the remote cord into the socket may result in faulty or interrupted operation.
4.
Before installing the battery, place it on the charging unit and let it charge for 24 hours. Make
sure the orange “charge” light illuminates when the battery is being charged. When the orange
charge light shuts off , the battery is fully charged.
5.
Remove the fully charged battery
from the charger and install it on top
of the control box. The battery will
line up with the control box, and will
‘click’ when it properly locks in place.
Apply dielectric grease to the plug
terminals, including the o-ring seal,
and then connect the battery cable to
the control box cable.
6. With the lift fully assembled, run
the lift fully out and back in 3-5 times,
without weight, for the lifts “break in”
cycle period.
WHEN NOT IN USE, STORE THE BATTERY ON THE CHARGER!
Ambassador Assembly Instructions
LOOP ON TOP
FOR EASY ACCESS
THREAD THROUGH
SLOTS AND PINCH
TOGETHER TO HOLD
FIGURE 7
ATTACH
FULLY-CHARGED
BATTERY
CONTROL BOX
1/2" X 1-1/2"
HEX BOLT (3)
1/2" FLAT
WASHER (2)
POOL
WALL
ANCHORS (3)
INSTALLED FLUSH
W/DECK SURFACE
1/2" EXTERNAL
TOOTH WASHER (1)
HANDSET
PLUGS INTO
CONTROL BOX
FIGURE 8
8
