MULTISWITCH
5. Configuration
5. Configuration
5. Configuration
5. Configuration
Via the five configuration-
jumpers (see chapter 4.5.
Jumper)
you
can
permanently
configure
single functions of the
multiswitch™. For this
purpose the included short-
circuit-bridges („jumper“)
are either removed from the
contact pins (position „open“) or set on the contact pins (position
„closed“).
The individual positions have the following functions:
Jumper position 1:
Jumper position 1:
Jumper position 1:
Jumper position 1: aquabus-address
aquabus-address
aquabus-address
aquabus-address
This jumper configures the aquabus-adress of the multiswitch™ when
connected as a aquabus-device e.g. to the aquaero. When connected
as a USB-device this function is ignored.
Jumper open:
Address multiswitch™ 1
Jumper closed:
Address multiswitch™ 2
Jumper position 2: Save configuration
Jumper position 2: Save configuration
Jumper position 2: Save configuration
Jumper position 2: Save configuration
When this jumper is set, the current condition of the outputs are saved
with each keypress (supprted only in devices with buttons) and
automatically loaded after a reset of the system . Additionally a save via
the PC-software aquasuite is possible. If this function is deactivated, so
is the function in the aquasuite software!
Jumper open:
Saving deactivated
Jumper closed:
Speichern activated
Jumper position 3: Deactivate PWM function
Jumper position 3: Deactivate PWM function
Jumper position 3: Deactivate PWM function
Jumper position 3: Deactivate PWM function
This jumper configures the output of PWM signals at the outputs of the
multiswitch™. In the default setting (jumper open) PWM signals are
generated at the outputs which allow for instance LEDs to be controlled
in brightness. You must
must
must
must check if all
all
all
all connected devices are able to
© 2005-2012
Aqua Computer GmbH & Co. KG
- 9 -
Gelliehäuser Str. 1, 37130 Gleichen
