AQC QDuct, Руководство по установке

Страница: 7 / 11

CUTTING QDUCT
®
LENGTHS
•
When making length adjustments in the field, AQC recommends to
cut the male end of the duct.
•
Cut outer layer to the desired length and exercise caution to make
sure not to cut the internal layer.
•
Cut internal allowing for a 3” protruding end.
•
Use the AQC provided UL 181 tape to tape all exposed joint openings
and refer to
Connecting QDuct Sections included on pages 3-5 of this document
.
QDUCT
®
BRANCH CONNECTION
•
Designate area of desired branch and place the duct section flush to the main trunk line
and ensure the duct is properly centered on the main trunk line.
•
Using a permanent marker, trace around the OD of the branched duct on the main trunk line to
create an outline.
•
Use a circular saw to cut the outlined area on the main trunk line. A hand saw may be required
to finish the cut de- pending upon the thickness of the duct and the depth of the saw blade.
•
Use a flat bar to remove the cut panel from the main trunk line.
•
All exposed joint openings must be taped using the AQC provided UL 181 tape before making a
connection.
•
Refer to Connecting QDuct® Sections included on pages 3-5 of this document.
•
Place a jacking strip on the bottom of the branch, then on sides of the branch and lastly on the top
of the branch.