AQC MAXIFLO-VC, Руководство пользователя

Страница: 9 / 29

Assembly
Required tools
The following tools and equipment are required
for the assembly of the dust collector:
·
Crane or lift truck
·
Spreader
·
Chains
·
Slings
·
Shackles
·
Eye bolts
·
Spikes
·
Wrench
·
Sockets
·
Power drill
·
Concrete drill bit
·
Concrete anchors
·
Bolts
·
Self tapping screws.
·
Caulking
Assembly
1.
Prepare the area where the collector will
be installed making sure it is clear and
free of any obstacle.
2. Using eye bolts, slings and shackles, lift
the dust storage section above the
selected area and set slowly.
3. Once this section firmly set to the
ground, make sure it is level. Use anchor
bolts to keep it in place.
4. Install a ground wire to the unit.
Warning !
Apply two strips of butyl adhesive on the
dust storage section upper outline. One strip
should be applied inward of the bolt holes
and one strip outward of the bolts holes
(drawing 3).
5.
Lift the filter cabinet using the lift lugs.
Using spikes, position the cabinet above
the dust storage section making sure to
align the cabinet bolt holes with the dust
storage section bolt holes.
Warning!
The use of a spreader is recommended to
avoid damages to the filter cabinet.
6.
Lower the filter cabinet onto the dust
storage section and align both sections
bolt holes.
7.
Attach the filter cabinet to the dust
storage section using the supplied nuts,
washers and bolts. Tighten bolts for an
adequate seal.
8. Use caulking to eliminate possible leaks.
Warning!

The use of improper lifting device
may result in injuries or damages.

Adequate lifting devices are required
and necessary precautions must be
taken when handling the equipment.
9