6
General Troubleshooting:
Always ask and check:
1. Is the unit connected to a live power source?
2. Check the circuit breaker.
3. Is power switch on and pilot light glowing?
4. Check the rating label. Are you operating unit on the proper voltage?
If the above checks out and you still have problems, call an APW Wyott authorized service agency.
INSTALLATION
Place the HOTROD
®
directly on a countertop or on a matching APW Wyott Bun Warmer or Bun
Cabinet (available separately). Place the unit close to an AC outlet, of the correct voltage, to avoid
undue strain on the power cord.
CAUTION
: To avoid equipment damage, make certain that the nameplate voltage is
the same as the outlet voltage.
If the plug is to be removed and replaced with a plug more suitable for your area, the color code for
the power cable is:
Neutral (N) = White or Blue Live (l) = Black or Brown
Safety Earth (E) = Green or Yellow/Green
After a suitable location has been chosen, wipe the rollers and the drip pan with a damp cloth. The
unit is ready for use.
CLEANING
Daily Cleaning Instructions:
1. Heat the unit.
2. Using a moist cloth filled with crushed or flaked ice, wipe each tube. Wipe the tubes from each
end to the center. This will keep as much of the loosened particles out of the bearings as possible.
Extend the cloth as far as possible between the rollers.
3. With the heated rollers wiped with an ice filled cloth to loosen the particles, now, wipe clean with
another cloth. Continue to wipe from the end of the rollers to the center. This will reduce the grease
and partials getting into the bearings and drive mechanism. This will extend the life of the unit and
extend the period between routine maintenance of the drive mechanism.
CAUTION:
NEVER use abrasive powders or pads; these cleaners may damage the
roller finish. Also, the particles may get into the drive mechanism shortening the unit life.
4. Remove the drip pan and wash it in hot, soapy water, then rinse.
5. If stains are still present, add a light detergent to the cloth and repeat.
6. Replace the pan and turn the unit off if the grill will not be immediately used.
Alternate Cleaning Method using optional 3M sponge (#21807305)
and cleaning handle (#21807300):
1. Turn heat down to lower setting (i.e. “hold” temperature) and allow grill to cool.
2. If the grill has considerable grease build-up, wipe the excess grease from the rollers with a lint free
towel or paper towel before using the soap and sponge.
3. Place sponge onto cleaning handle.
4. Immerse sponge in warm, soapy water.
