5
INSTALLATION
NOTICE: These procedures must be performed by qualified personnel or warranty
will be voided.
CAUTION: Check the data plate on this unit before installation. Connect the unit
only to the voltage and frequency listed on the data plate. Connect only 1 or 3
phase as listed on the data plate.)
1. Uncrate the Coldwell and place it in the approximate location. Make sure no parts are discarded
with crating material.
CAUTION: This device should never be positioned upside down or on it.s side.
If the unit arrived or was stored in any position other than this end up as marked
on the shipping container, then allow the unit to set upright for 24 hours before
applying power or turning on the unit. Failure to do this will cause the unit to
function incorrectly. The unit will not be able to cool to the desired temperature.
2. Set the Coldwell in the operating location.
CAUTION: One inch minimum clearance must be maintained between wall and unit
on any side with louvers.
3. For best results install on a stainless steel counter top. Can be positioned on any sturdy surface.
ELECTRICAL CONNECTIONS
Check the data plate to determine what voltage this Coldwell is wired for and what voltage service to use.
WARNING: Improper grounding could result in electrical shock. This appliance
is equipped with a three-prong (grounded) plug for your protection against shock
hazard and should be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from this plug.
OPERATION
Equipment Preparation:
Clean the Coldwell before using. Wipe well and frame with a hot, wet cloth to remove any shipping
dust or protective oil.
Operating /Seasoning Instructions:
Operation: Plug Coldwell in and turn on the power switch. The unit has been
calibrated at the factory for 35° - 39° at sea level. Wait about 45 minutes for the
unit to cool. If the product is too cold or too warm adjust the thermostat. The
thermostat adjustment is located on the rear panel of the unit above the power
cord. To access the thermostat adjustment, remove the hole cover to reveal flat
screwdriver adjust shaft. 1/2 turn clockwise on the thermostat decreases the
temperature approximately 6°F and 1/4 turn counterclockwise on the thermostat
increases the temperature approximately 6°F. If you are unable to set your
Coldwell to the desired temperature contact your factory authorized service
agent for the adjustment.
1. All food service equipment should be operated by trained personnel.
2. Never hold food below 150°F or above 40°F.
WARNING: This unit is not intended to hold potentially hazardous foods such as
uncooked or unpreserved meats and sausages.
