5
AU
Telephone Helpline: 1300225960
Continuous blending
Follow steps1 to 5 as above, then:
1. While the ON/OFF button is in the depressed
position, press the LOCK button (4).
2. Now release the ON/OFF button. The appliance
will function continuously.
3. To stop the appliance, just press the ON/OFF
button once.
• For greater control, we recommend
holding the blender by the handle
and the bottom of the power pack.
Furthermore, it is recommended to tilt
the bender slightly to prevent the blade
guard from touching the bottom of the
container.
• Always make sure that the blade
guard is sufficiently immersed to avoid
splashing and that the air vents of the
motor unit does not come into contact
with any liquid. For optimum efficiency,
two thirds of the shaft should be
immersed during preparation.
• During use, the stainless steel shaft may
become hot. Take care not to touch it.
• It is advisable to start at a low speed.
Removing the lodged food
If a piece of food gets lodged in the protective
blade guard surrounding the metal blade, please
follow the instructions below:
1. Turn off blender, disconnect from power supply
and let it come to a complete stop.
2. Remove the shaft from the power pack.
3. Use a spatula to carefully remove the food
lodged in the blade guard.
The blade is
sharp - Never attempt to use fingers to
remove any lodged object.
4. Re-attach the shaft, plug unit back in and
continue blending.
Changing the blade
Warning: Before removing blade, ensure
to turn off blender, disconnect from power
supply and let it come to a complete stop.
Blade is sharp - handle carefully.
• A triangle blade is pre-mounted on the shaft.
• A round emulsifying blade is also supplied,
ideal for use with nursery/special diets to
prepare purée of vegetables, porridge, raw
carrot purée, fruit creams, etc. To use it:
1. Remove the shaft from the power pack.
2. Using the triangle blade removal kit, with the
round end holding the shaft top while the
triangle end covering the blade then unscrewing,
remove the triangle blade from the shaft.
Blade removal kit
3. Mount the emulsifying blade securely using the
emulsifying blade removal kit.
Cleaning, Care &
Maintenance
Warning: Always ensure to
disconnect unit from power supply,
let it cool down and come to a
complete stop before cleaning.
• After use, clean in time to prevent food from
sticking to surfaces.
• Clean the power pack surface using a damp
cloth. Always wipe dry after cleaning. Never
immerse the motor part in water or rinse it
under running water.
• Do not allow any moisture to enter the interior
via any ventilation slots.
• The appliance contains on user serviceable
parts. An APURO dealer or qualified technician
should carry out repairs if required.
Cleaning the shaft, blade guard, and
blade
• Remove the food residue as much as possible.
• Place the shaft and blade guard into a
container with water, then switch on for a few
seconds for thorough cleaning.
•
WARNING:
Always dry the blades well after
cleaning to avoid spotting.
• It is vital to clean thoroughly between each job
using a detergent or disinfectant, but never
use pure bleach. For plastic parts, do not use
detergents that are too alkaline.
FS440-A_FS441-A_FS442-A_A5_v1_20211117.indb 5
FS440-A_FS441-A_FS442-A_A5_v1_20211117.indb 5
2021/11/17 17:27
2021/11/17 17:27