3
Operation
1.
Cut the meat into small enough pieces to fit in to the hole in the hopper tray.
2.
Turn the power switch ON.
3.
Feed the meat into the shaft using the food pusher.
If the circuit breaker stops the appliance or the appliance becomes jammed:
1.
Turn Off the appliance immediately.
2.
Press the RESET button located at the back of the appliance above the power cord.
3.
Turn and HOLD the switch in the reverse position to clear the blockage.
4.
Remove and clear the mincing barrel and all components.
Cautions
•
When carrying the unit, hold the Motor Housing with both Hands, not to hold only Plate.
•
Be careful to carry the unit because it is very heavy.
•
Do not grind hard food such as bones or nuts.
•
Do not grind food with hard fiber (e.g. ginger).
•
The air passage at the bottom and the side of Motor Housing.
•
To avoid jamming, do not force to operate the unit with exessive pressure.
•
Do not unplug the appliance by pulling the cord. To unplug, grasp the plug not the cord.
•
Make sure that the voltage and frequency indicated on the rating plate are the same as your local
supply, and that the external earthed wire is reliable connected.
•
The appliance should be used strictly in accordance with these instructions as no liability can be
accepted for any damage caused by non-compliance with these instructions, or any other improper of
handling.
Note: Clean the appliance with warm soapy water and dry thoroughly before using for
the first time.
WARNING: Never push the meat into the shaft using your fingers.
Содержание CD400-A
Страница 1: ...Meat Grinder Instruction manual Model CD400 A...
Страница 8: ...CD400 A_v2...
