COLLISION ALERT SYSTEMS
APS-SUPPLY.COM
www.aps-supply.com
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
When the sensor reports a detection within the maximum detection range set
in the “Distance Alert Screen” (page 8), the check mark will be replaced by a
yellow triangle (Figure 16). The audible will also change to the “Warning” sound
to notify you that an object has been detected.
Figure 16. Active Screen, Warning
The display provides three different warnings to the machine operator that
change based on the distance to the detected object. 1) The audible warning
sound will increase in rate and volume as the machine gets closer to the detected
object. 2) The yellow triangle’s flash rate will increase in the same manner as
the audible warning. 3) The five zone boxes on the left side of the screen will
continue to illuminate until all five boxes are filled.
When the distance to the detected object reaches the close-in detection zone as
set in the “Distance Alert Screen”, the yellow triangle will be replaced by a red
stop sign and the volume will increase to the highest level as set in the “Volume
Adjust Screen”.
Figure 17. Active Screen, Close Detection
The audible warning can be silenced at any time by simply pressing anywhere
on the screen. The audible will not become active again until the detection
clears.
The Home screen can be reached while the Active screen is displayed by
executing a long press on the screen. After pressing the screen for at least
1 second the message on the bottom of the screen will change from “Hold
& Release for Options” to “Release”. Once the “Release” message pops up,
release your finger from the screen and the Home screen will be displayed
(Figure 2.1). Follow the procedure shown in “Configuring The Display” starting
on page 2 to make any adjustments to the display. If nothing is pressed and
the machine is still in reverse, the display will revert to the Active screen after
5 seconds. If you enter the Settings Menu and want the system to return to the
active screen, simply press the icon.
