APRILIA RSV MILLE, Руководство по ремонту

Страница: 81 / 386

SERVICE AND SETTING UP
2 - 32
RSV mille
#(%#+).' !.$ 4/00).' 50 4(% 2%!2
"2!+% &,5)$
Brake fluid:
for the maintenance intervals, see 2.1.1 (REGULAR
SERVICE INTERVALS CHART).
a
CAUTION
If the brake lever features excessive free play, if it is
excessively spongy or in the event of air bubbles in
the circuit, bleed the system, see 2.20 (BLEEDING
THE BRAKING SYSTEMS).
The leak of brake fluid damages painted or plastic
surfaces.
Before setting out, make sure that the hoses are not
twisted or holed and that there are no leakage from
the connectors.
Do not use or mix different types of silicone or oil-
based liquids.
Do not use brake fluids taken from old containers, or
not sealed.
Prevent water or dust from accidentally getting into
the circuit.
CHECK
NOTE
Position the vehicle on firm and flat ground.
◆
Keep the vehicle in vertical position, so that the fluid
contained in the tank (1) is parallel to the plug (2).
◆
Make sure that the brake fluid contained in the reser-
voir exceeds the “
MIN ” mark, by checking through the
appropriate slot on the right fairing”.
MIN = minimum level.
MAX = maximum level
If the fluid does not reach at least the “ MIN ” mark:
a
CAUTION
When the disc pads wear out, the level of the fluid de-
creases progressively to compensate for their wear.
◆
Check the brake pad wear, see 2.27 (CHECKING THE
BRAKE PAD WEAR)and the disc wear.
If the pads and/or the disc do not need replacing, provide
for topping up.
TOPPING UP
◆
Remove the right fairing, see 7.1.28 (REMOVING THE
SIDE FAIRINGS).
a
CAUTION
The brake fluid may flow out of the tank.
Do not operate the rear brake lever if the brake fluid
tank plug is loose or has been removed.
◆
Unscrew the screw (3) completely.
◆
Slightly move the whole reservoir (1) outwards.
Follow
ã
Release 00/2002-10
- 00