5
Step 6.
6.1
Drill 3 equally spaced holes with a 3mm drill bit through the wall profiles and frame.
6.2
Fix the frame to the wall profiles using the screws ST3.9 × 16 (3 per wall profile).
6.3
Drill 3 equally spaced holes with a 3mm drill bit through the inline post and frame.
6.4
Fix the inline panel with the frame using screw ST3.9 × 16 (
No.13
- 3 per wall profile).
Step 6.1
Step 7.1
Step 7.4
Step 7.2
Step 7.5
Step 7.3
Step 7.6
Step 6.3
Step 6.2
Step 7.
7.1 Position the support arm on the inline panel.
7.2 Level the arm using a spirit level. Once you are happy that the support arm is in correct position, mark the wall thought
the screw hole and around the wall fixing. Also, tighten the M8 socket set screw which you can see using the 5/32 allen key.
7.3 Loose the M6 countersunk screw using the 5/32 allen key.
7.4 Remove the arm and the wall fixing, drill the marked points using a 6mm masonry drill bit. once this is done insert 2 x wall
plugs (
No.12
).
7.5 Fix the wall fixing using 2 x countersunk screw ST4 x 30 (
No.14
), then put 2 x screw cap on (
No.10
). Also, tighten the
other M8 socket set screw into the glass clamp.
7.6 Place the arm again and tighten the M6 countersunk screws using the 5/32 allen key.
Note:
need to replace
the wall fixing to the
glass clamp when the
inline panel fits with the
side panel as above
shown.
Step 6.4
Side Panel
Glass Clamp
Inline Panel
