Enrolling a new finger
If there are less than 5 fingerprints enrolled and you want to enroll a new finger,
follow the instructions below.
1.
Plug in the Aegis Bio to a USB port on your computer.
The LED should
be Solid
RED
indicating that the drive is Standby mode.
2.
Push the ENROLL button for 3 seconds.
If less than 5 fingerprints are enrolled, the
BLUE
LED will become Solid
BLUE
and
RED
LED will remain illuminated. Proceed to Step 3.
If 5 fingerprints are enrolled, the
BLUE
and
GREEN
LED will come on for 2
seconds and the
RED
LED will be Solid
RED
. You will not be able to enroll
any more fingerprints.
3.
Swipe a finger that has been previously enrolled.
The
GREEN
LED will
flash if the fingerprint is accepted. If the fingerprint is not accepted the
RED
LED will flash.
4.
Once the fingerprint is accepted the
BLUE
LED will become Solid
BLUE
and
the
GREEN
LED will continue flashing, indicating that the Aegis Bio is ready
to enroll a new fingerprint.
5.
Swipe a new finger.
The
BLUE
LED will turn off while the
GREEN
LED
starts to flicker briefly as the Aegis Bio processes your new fingerprint.
Wait until the
BLUE
LED turns back to Solid
BLUE
and the
GREEN
LED
returns to its flashing state.
6.
Repeat Step 5
until both the
BLUE
and
GREEN
LED are in a solid state,
indicating that your fingerprint is fully enrolled.
NOTE: Once enrolled, fingerprints cannot be un-enrolled individually. To
remove enrolled fingerprints, a complete re-set of the drive is required.
Apricorn provides the following helpful resources for you:
1. Apricorn’s Website (
http://www.apricorn.com
)
This gives you the ability to check for up-to-date information
2. E-mail us at
3. Or call the Technical Support Department at
1-800-458-5448
Apricorn’s Technical Support Specialists are available from 8:00 a.m. to
5:00 p.m., Pacific Standard Time Monday through Friday
Technical Support
