Adjustment of parameters
Main control unit FBSN – 8D is equipped with service display and two
push-buttons. It enables to display and adjust some parameters of device.
WARNING! Unprofessional manipulation with parameters can seriously
limit utility of device!
Display shows:
F
ACTORY
S
ETTINGS
,
or
C
USTOM
S
ETTINGS
– if one or more parameters are adjusted in a
different way from factory
By long push (longer than 2 seconds) of whichever button, activation of
service state occurs. Display shows number of chosen parameter.
Choose desired parameter by means of buttons – down by left button, up by
right button.
By long push (longer than 2 seconds) of whichever button value of chosen
parameter is displayed. Value is blinking.
Change the value of parameter by means of buttons down by left button, up
by right button.
By long push (longer than 2 seconds) of whichever button new value is
stored and number of chosen parameter is again displayed.
Termination of service state is done automatically, if no button is pushed for
certain time.
FACTORY SETTINGS RESTORING: by simultaneous long push
(longer than 2 seconds) of both buttons.
Parameters review
NUMBER DESCRIPTION
RANGE
FACT. SET.
NOTE
01
Volume of the speaker
0, 1, 2
2
0=off, 1=low, 2=high
02
Range of front central sensors
50 – 95 [cm]
80
03
range of front corner sensors
50 – 95 [cm]
55
04
range of rear central sensors
120 – 180 [cm]
160
display shows 20 - 80
05
range of rear corner sensors
50 – 95 [cm]
55
06
STOP zone of front central sensors
25 – 50 [cm]
35
07
STOP zone of front corner sensors
25 – 50 [cm]
25
08
STOP zone of rear central sensors
35 – 70 [cm]
35
09
STOP zone of rear corner sensors
35 – 70 [cm]
35
10
Suppression of spare wheel indication 0, 1
0
1 = activated by jumper
11
Number of speed signal pulses
1 – 99 [pulses/m]
3
12
Delay of front sensors deactivation
0, 10 – 60 [s]
0
0 = function not activated
13
Delay of rear sensors activation
0, 1
0
1 = for automatic gearbox
15
Service display
0, 1, 2, 3
0
0 = function not activated
1 = distance of the nearest front obstacle [cm]
2 = distance of the nearest rear obstacle [cm]
3 = calculated vehicle speed [km/h] (test of the speed signal and parameter No.11 setting)
16
Front obstacle indication
0, 1
0
0 = nearing obstacle only
1 = all obstacles
Note: STOP zone = distance from sensor, from which the obstacle is indicated by continuous tone.
Содержание FBSN-8D
Страница 2: ......