Electronic parking system FBSN-8D
System consists of following parts:
•
4 front sensors (1) (marked with green colour) are installed in a front bumper.
•
4 rear sensors (two central (2) are marked with black colour, two corner (3) are marked with blue colour)
are installed in a rear bumper.
•
Main control unit (4) with display and operating buttons is placed under the dashboard.
•
Rear control unit (7) in a boot.
•
Front cable harness (5).
•
Rear cable harness (8) with link cable for data transmission from rear to main control unit.
•
Speaker (6)
Description of the function
After switching the ignition on, front sensors are activated. Detection of obstacles and their signalling is launched
immediately. After shifting into reverse gear you can hear control signal. Now, either front and rear sensors are
activated. Obstacles are signalled audibly by speaker. The faster beeping the closer obstacle is. Volume of the
speaker can be adjusted (see chapter Adjustment of parameters). Zones R1, R2, R3 and front zone F (see picture
ZONES OF DETECTION) are also distinguished by height of tone. Continuous tone – STOP zone FC, RC.
Range of separate zones can be adjusted to vehicle geometry (see chapter Adjustment of parameters). Obstacles
which are not approaching are signalled by front sensors only in STOP zone.
To avoid undesirable signalling, utilise possibilities of the sensor deactivation:
•
Automatic deactivation of the front sensors, if the speed exceeds approximately 10km/h.
•
Push-button (option, code SWEPS8006F ) for temporary deactivation of the front sensors. Lighting push-
button indicates, that the front sensors are active. By short push deactivate front sensors until the next shifting
into reverse gear or the next ignition switching ON, by long push (longer than 2 seconds) until the next
ignition switching ON. Sensors can be activated any time by pressing push-button again.
•
Time window - if signal of vehicle speed is not at disposal. Front sensors are then active only after the
ignition switching ON or after shifting into reverse gear or pushing the push-button. Deactivation is done
automatically after certain time since ignition switching ON or reverse gear rejection or pushing the push-
button (see chapter Adjustment of parameters).
•
DISABLE input - cable box (8), pos.19 - by connecting to the chassis (pos.7): rear sensors can be
deactivated by switch (option, code SWEPS8006R) or by towing bar socket.
If MUTE function is used, car audio is automatically faded-out during indication of obstacles.
WARNING: Even with electronic parking system installed it is necessary to watch surroundings of the
vehicle carefully during manoeuvring. Small obstacles and items with low reflectance do not have to be
captured by the system.
Содержание FBSN-8D
Страница 2: ......