Appsys ProAudio ADX-32B, Руководство пользователя

Страница: 9 / 20

ADX-32B / ADX-64B-PRO
7. REAR PANEL
7.1. POWER Connections
Connect the supplied DC adapter(s) here.

The input „SECONDARY POWER“ is only available in the ADX-64B-PRO and allows you to connect a second
(redundant) power supply. Both power supplies work independently, and if one of them fails, the other one
takes over. This is particularly useful to make the system immune to failure of a single AC phase in 3-phase
supplies. The status of the respective supply is shown on the corresponding front panel “Power” LEDs.

Use only the supplied DC adapter, or a replacement with the indicated voltage, power, polarity and matching
connector (see 12. Specifications). The input has a reverse-polarity protection.
7.2. ADAT 1-4
The transmission direction (TX or RX) must be set using the DIP switches 1-4:

Input (DIP switch in lower position = OFF): The ADAT connection is configured as input,
the received data is sent to the Cat5 cable.
The input signal is passed-through to the output alongside ("local loop-back"). You can use this
output to connect additional monitors or as wordclock source, as shown in
7.2. Synchronization
over ADAT .
If you're using a daisy-chain of ADX devices, make sure that there is exactly one “Input” per ADAT connection
in the chain.

Output (DIP switch in upper position = ON): The ADAT connection is configured as output.
Data received from the Cat5 cable is output on the “Output” jack. The input jack is inactive.
9
1 2 3 4 5 6
ON
Cat5 Connection 1
1
IN OUT/THRU
MIDI1
IN OUT/THRU IN OUT/THRU IN OUT/THRU IN OUT/THRU
2 3 4
OU
T
CH
1
OU
T
CH
2
OU
T
CH
3
OU
T
CH
4
IN IN IN IN