ApPower™
6
picture
：
5
The left one in the picture is Output port: 1for anode, 2 for cathode;
The right one is Input port: L for anode, N for cathode.
Notice: When you plug an external connection to the socket, as shown in the
schematic wiring polarity, be sure correspond do not connect reversely, and
when use multimeters to measure voltage, do not put 2 multimeter pens
together to prevent short-circuits.
Section VI: Suggestions
1. Solar OPS best working temperature is 15
C
45
C due to cell characteristics. The
temperature too high or too low will cause partial power cannot be released and that
would shorten service time of load-end.
2. Solar OPS is better to charge 40%
60% of capacity and keep the packs in room
temperature storage while battery long does not use.
3. The Company is not responsible for any accident caused by operating does not
comply with this manual.
