Applifast HK961, Инструкция по эксплуатации

Страница: 17 / 36

2580 series Hydraulic Installation Tools
(HK961)
17
15. 2580: Assemble electrical cord to connector.
Screw strain relief grommet into handle.
Push cord through grommet. Attach cord to
trigger switch. Press switch into handle and
tighten set screw against switch. Pull excess
cord down through handle and strain relief
grommet. Tighten grommet.
A2580: Thread hose fitting into handle.
Attach quick disconnect to airline. Attach air
line to to handle’s hose fitting. Screw air trig
ger assembly into handle’s trigger fitting and
tighten set screw against fitting.
16. See CAUTION in 14. - - screw coupling nip-
ple onto PULL pressure hose (from “P’ port
of tool). Screw coupling body onto RETURN
pressure hose.
17. Before attaching nose assembly and using
tool, read entire PREPARATION FOR USE
section. Hold 3/8” hex wrench in back of tool
when tightening collet. Use pintail tube if
necessary.
18. See WARNING in DISASSEMBLY and
reverse the given procedure i. e. CONNECT
HOSES FIRST . and then, connect electrical
control cord.
Subassembly Part Numbers and Notes
Refer to Illustrations
1 A matching 12 ft. Hose Kit, 122854, is available.
2 123139 - Front Grand Assembly includes:
3 123136 - Piston Assembly includes:
4 123142 - Rear Gland Assembly includes:
5 123338 - Trigger Cord Assembly includes:
6 CAUTION: Install cups of POLY-SEALS and wipers as shown.
7 Torque screw, 506030, to 20+/-3 in. lbs.
8 Blind fasteners require pintail tube, 108279.
A
A
SSEMBLY
SSEMBLY
(
(
CONTINUED
CONTINUED
)
)
CAUTION: Anvils with ears must have stop
installed in position as shown to prevent
damage to ears - - slide stop over anvil
before installing retaining nut.