3
Status LED’s
These LED's remain lit as long as there are no electrical faults
with the cabling or the pedal you are supplying power too. If a
particular fault seen at one of the outputs, the LED dim or turn
off and the voltage at that output will diminish. The cable
connection on the output with the fault will have to be removed
and reconnected for the output to be reset.
SAG Voltage
To enable this function on voltage output1 the dip switch will
need to be set to 4-9v. Then the user can vary the voltage from
the pot on the unit face.
APPLICATIONS
The ART ISO-8U is designed so that it can be mounted on a
pedal base using Velcro. The front and sides are recessed to
protect the cables and controls.
The bottom edge of the ISO-8U has slots that allow you to use
cable ties to control the routing of the power cables. Once you
loosely insert the wire ties through the slots you can run the
power cables through the remaining loops. Once all of the
cables are in place, you can tighten down the wire ties.
